DenisC
I’ve been having sporadic problems with my control board.  Most recently Buckshot and Peddler helped me with a charging problem.  

Is the 0H6680DSRV conversion kit something a homeowner can successfully install without some kind of secret programming codes?  I realize it is an expensive upgrade but in the event I need to replace it I want to be sure I know what I’m getting into.  I see a few posts on the forum about how to route wiring, etc for the retrofit kit but could not find anything explicit regarding programming.

Thanks in advance.
Quote
78buckshot
The wiring is all plug-n-play, you'll have to drill a couple of 1/4 in. holes to mount the interface module.  Digital set-up is the same as your original control.
Quote
DenisC
78buckshot wrote:
The wiring is all plug-n-play, you'll have to drill a couple of 1/4 in. holes to mount the interface module.  Digital set-up is the same as your original control.

Thanks Buckshot!
Quote
jacobeis
I have a 58751 it uses the OH6680D Controller when I press Enter all I get is GIBERASH Generc says I have to replace the whole unit
Over $700.00 although the Generator will still work 
anyone know if i can just change the digital display panel
Quote
grsthegreat
Jacobeis ,i have no idea where you would get one from, they dont sell controller separate parts. i guess you could get a damaged controller and try it. the display has like 30-40 solder points.

have you tried unplugging all control wires from board while unit is powered down and rebooting controller
Quote