151now
hi, to you all out there. im trying to locate information on the valve clearance specs for a generac 3800 psi pressure washer. the engine is a generac 302cc. I checked the valve clearance and the valves are set at .006th on each valve at TDC. if I had only known the specs I would of changed it or known that the .006th was right. if anyone can offer me any advice on the matter would be appreciated. thanks jim
Quote
78buckshot
The specs for all of Generac's single and twin cylinder generator engines is .002 - .004 in. with a cold engine, power washer I don't know but .004 is probably safe.
Quote
151now
.002 seems awfully tight for my satisfaction too, but if that's the specs I think ill stay closer to ..4 also. thanks for the reply. I wish I knew where to obtain a manual of some type. I have looked over the internet without any success so far.
Quote
78buckshot
That's all I can offer, the company I work for deals only in their generator line.
Quote
151now
thank you for the replies
Quote